1. Why a DC motor starter is called 3 point starter
Answer Posted / sundar
Because they have three terminals namely line field and
armature. they are connected with the motor respectively,
Is This Answer Correct ? | 31 Yes | 12 No |
Post New Answer View All Answers
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Why neutral is not used in three phases dol starter
What is the function of the generator exciter?
What are chief characteristics of state-space method and its techniques ?
how to control dc motor?
How LT megger works ?
What is dynamo function in DG sets and draw block diagram?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
what happen if drive input fail momentry at 48.5 HZ frequency?
which type of stability limit is higher,steady state or transient? why?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
How many types oil using in transformer ? How many letars using in transformer..?
Define early construction of human being