Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 18949 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / sidhu.k.
actually, question is wrong see,neutral and phase terminals
are equal sizes,but earth terminal size is bigger than
both,as per question why nutral point is high diameter,as
per my experience ihave never seen nutral point is big
diameter.anyway allready lot of guys are given the
answer,about why earth point is bigger, ok,i also come to
the original matter,if in case short circuit is happened,in
that plase heavy currentis produced. that current going
through this earth point.due to this process we avoid heavy
accident.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
What is the feedback in the control system?
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
what does a k rating in a transformer means?
physical identification of HT & LT panel
What it the purpose of parallel phasing transfomers??
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Which device is used for the source of emission of electrons in a crt?
Why generation voltage in thermal power plant is between 11kv to 33kv?
