what is the voltage between the earth & neutral
2 is there any continuity TO BE between earth & NEUTRAL
- 3 Answers
- 9512 Views
- Suzuki, I also Faced
- E-Mail Answers
Answer Posted / abdul salam
The exact voltage between earth and neutral can not be
forecast because it ia not a fixed quantity it depends upon
the how effective neutral earthing is provided to the
system and howmuch unbalancing of load is present in the
system, ideally it should be zero but can not be achieved
as some unbalancing is always there in the system.
There should not be any continuity between earth & neutral.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
how to calculate current and voltage in a same circuit?
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
How to test IR testing & magnetic balance test
Why we are going for converter transformers for DC drives application instead of distribution transformer?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
describe the Tranformer testing procedure
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to convert 2 phase to 3 phase electricpower in induction moter?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
define digital electronic
