Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between power and distribution
transformer?
- 32 Answers
- 68975 Views
- L&T, VJTI, Wenke Electricals, I also Faced
- E-Mail Answers
Answer Posted / shvetang dave
Power Transformer are used for step up purpose from
trnasmission station to distribution station. Normally from
750 KV to 11 KV it is to be used. It is design for only I2R
losses b'coz Iron losses are constant b'coz it is operated
for constant application.
Whereas distribution Transformers are used for step down
purposes b'cos it is used for distribution purposes. It can
be used for Factory's required power as well as in society
it can be used for home's use. It can be used for 11 kv to
230 Voltage purposes. It can be Design for iron losses
b'coz It is operated for 70 to 80% operation so I2R losses
are not so much important
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
How can we choose the rating of submersible motors
what is EIB lighting control system? what is the advantages of this system?
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
Zone of protection and tripping scheme of arc protection relay.
What are the raitings of Mcb,mccb and Acb in detail ??
What is mean by hot and cold loop testing?
What is the problem of internal failure in ship engine telegraph system norcontrol?
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What is the control action?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
