Answer Posted / thowsif_emerson
Purpose of Using a Harmonic Filter:-
Reduces neutral currents,
Reduces transformer loading,
Protects electrical systems,
Reduces fire hazard,
Protects the neutral conductor,
Enhances system protection,
Minimizes impact on distribution transformers,
Reduces local neutral to ground voltage,
Lowers peak phase current/average phase current,
Increases system capacity...
Decreases system losses,
Improves power factor on non-linear loads,
Reduces total harmonic distortion,
Improves phase current balance,
Augments phase voltage balance.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
CBCT selection
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
How one can check the MAIN of a house wiring ?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
How to calculate fault level of 11 KV system
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
how to estimate wiring ins roughing ins. and boxes
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
