Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference when selecting a cable between AC
and DC current?
- 13 Answers
- 55070 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rama
The average curent of DC is higher than AC .Same thumb rule
is used for selecting cable either DC or AC but insulation
depends on voltage level.
The loss in DC transmision is less than in AC transmission.
| Is This Answer Correct ? | 6 Yes | 13 No |
Post New Answer View All Answers
why the protection turbo generators is most complex?
What is resistance reading of earth copper rod with grid and without grid?
whats the differece between Exd and Exe
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
what is the principle of operation of CFL ??
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Why a tesa lamp is glow between two phase?
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
Graphs of measuring power and speed on dc motor
draw the block diagram of fire alarm?
How many gap between finger contact in a.c.b. and v.cb.?
