in Megger what type of voltage(AC or DC) are produce.how
they work.
- 1 Answers
- 12208 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik raman.b
The megger is a portable instrument used to measure insulation resistance. The megger consists of a hand-driven DC generator and a direct reading ohm meter. A simplified circuit diagram of the instrument is shown in Figure 17.
The moving element of the ohm meter consists of two coils, A and B, which are rigidly mounted to a pivoted central shaft and are free to rotate over a C-shaped core (C on Figure 17). These coils are connected by means of flexible leads. The moving element may point in any meter position when the generator is not in operation.
As current provided by the hand-driven generator flows through Coil B, the coil will tend to set itself at right angles to the field of the permanent magnet. With the test terminals open, giving an infinite resistance, no current flows in Coil A. Thereby, Coil B will govern the motion of the rotating element, causing it to move to the extreme counter-clockwise position, which is marked as infinite resistance.
Figure 17
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
what is the criteria for selection of conductor used for ehv ac electrical dischrge
What is the power requirement of tamil nadu for one month?
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
How do we find the rating of a transformer, if it got burnt badly.
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
If not into production, how far did you follow the design and why did not you see it into production?
Explain what is rated speed?
describe the phenomena of vacuum interruption in C.B
What is an automatic controller?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
how many joint can done in HT line and what is life of the joint
how to flameproof electrical motor on the shaft?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
Discuss about gear cutting machines.
how to calculate mf when meter and cTPT detail are given
