1.wat is the advantage of induction motor?
2.wat is diffrence between 1-phase and 3-phase induction
motor?
Answer Posted / kapil bahadure
the advantage of induction motor:-
1} smoller in size.
2} light in waight.
3} less maintaning cost.
4} easy to repair.
5} less sparking produced.
6} it is cabonless.
the diffrence between 1-phase and 3-phase induction:-
1} 1-phase winding created in 1-phase I.M.&three phase
winding created in the 3-phase I.M.
2} changing magnetic flux produced by 1-phase I.M.&
rotating magnetic flux by 3-phase I.M.
Is This Answer Correct ? | 22 Yes | 5 No |
Post New Answer View All Answers
What is the different between digital phase converter and ordinary phase converter?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
how did the testing of protection relays done through current injection
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
How does a digital electronic meter work??????
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is meant by residual over voltage & residual earth fault ?
How to measure the earth resistance value in a concrete pavement(flood light area)?
What is Traction? 1KVA Alternator, How much urrent taken?
What is the earth treantment procedure?
Why in ESP Positive earthed
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
What is the difference between diode and a transistor in terms of the direction of current flow?
how to calculate transformer load?