Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the stanchan Height for installation of
Smoke detector & toxic gas detector in field,according to
qatar standard
- 2 Answers
- 6645 Views
- I also Faced
- E-Mail Answers
Answer Posted / வி
Height Factor should not be considered for Installing detectors both Smoke Detectors and Toxic Gas Detectors.
And there is no standards for countries such as qatar.america.
The concept is where the emission exists of gas leak or smoke,
while installation we have to be aware of Future preventive Maintenace. The Installation should be such it has to sense the existience of gas and it should be suitable place for calibration,preventive maintenance,and for corrective maintenance.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the minimum power (P=VI)to produce a spark?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
How digital input and digital output 's are working in dcs
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How to calibration a control valve?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
what is The specifications for oriface instalation
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
