Answer Posted / pankaj
calibration is process in which we compare
the operational element with the standard element.
Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
How flow can be measured with dp?
What is the difference between working pressure and calibration pressure of a control valve
kindly sent some demo question and answer
How to Calibrate Flow Switch in field
What is limitation of the ht.of the displacer of a level trol?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
what is the calibration procedure for transweigh make weigh feeder?
what is the procedure of belt scale calibration?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
What is megering????
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is the reset offset and control system in instrumentation
how works encoder in plc
how to work MIL contol valve posistioner ?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in