Rotor is taken away from three phase induction motor and
three phase supply is given to the stator.What will happen?
- 9 Answers
- 9338 Views
- I also Faced
- E-Mail Answers
Answer Posted / x man
flux loss
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the disadventage of gland earthing(power cable) if any. ?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
do you have some of interview Questions in power and genrator section in general whith answers
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What is the effect of positive feedback on stability of the system?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
1.how many types of relays? 2.difference between ATS& STS?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
What are the advantages of nichols chart?
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
what & how to check the lightning arrester
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
What is 11 N1 and 12 N2 in single phase Transformer ?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
