Why Transistors are not used as switching devices?
Answer Posted / biraj kundu
transistor are mainly current driven whle for switching are
done at high frequency and high voltage. thus devices like
SCR,IGBT,MOSFET,etc are used.
transistors are employed in small ckts
Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what is the minimum voltage require to injure our body?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
In a single how much maximum current and watts using
What is the difference between Generator Differential Relay and Transformer Differential Relay?
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
Difference between Earthing Truck & Earthing trolly for HT panel
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What is the name of the winding to which supply is given?
What mean by MLTP
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?