Answer Posted / mohit.k.k
pt 100 is instrument for detecting temperature and it is
resistance temperature detector ( R.T.D) detects resistance
of platinumused in it. range is about -200 to around 800*C.
it has resistance of 100 ohm at o degree celesius.
| Is This Answer Correct ? | 48 Yes | 3 No |
Post New Answer View All Answers
How can we increase the capacity of Energy.?
How many gap between finger contact in a.c.b. and v.cb.?
What is called grain-oriented laminations?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
Write a note on materials used as a fuse element.
what you have to see after one week or month from the day of installation of transformer ?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
What is different bewteen low or high impedance busbar protection scheme
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
What is the working principle of MIG welding? and its out put Voltage?
What happens if we connect a single phase energy meter in reverse polarity.
Name the component u would expect to find in a switchgear assembly?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
