Why HT cable have only 3 core ?
Answer Posted / sanjay chauhan
Basically the HT cable is used for transmission line only
not in distribution line. Because we are using delta
connection (Three phase Three wire system) for transmission
and star connection (Three phase Four four wire system). So
that's why the HT cables have three cores only.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
please send me previous year questions of jspl through which i could prepare myself for the test.
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
What is the difference between cylindrical-type and sandwich-type winding?
transformer phasor diagram under load explain it?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
What are IR values and what it should be for coil and for insulator
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
what is relay what is protection & contact multiplying relays where it is used function in brief
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)