why companies are using First and third angle projection?
why not second and Fourth?
- 7 Answers
- 24172 Views
- CADD, I also Faced
- E-Mail Answers
Answer Posted / sushil kumar giri
because in 2nd and 4th angle projection topview and frontview overlap each other.
| Is This Answer Correct ? | 88 Yes | 9 No |
Post New Answer View All Answers
What is the purpose of air blow?
What is the purpose of starting air?
what is the difference between pipe and a tube?
how can we calculate the size of bearing with the size of plummer block?
If Seller is Registered with Karnatka State and Selling the Engg. goods to Delhi based non registered company, then what is the CST they charge?
What type of pump is are commonly used in auxiliary boilers?
How to detect staring valve leaks?
Draw the flow of F.O. diagram from service tank to Main Engine?
I need BHEL Engineer Trainee written test papers in Mechanical stream.
hello sir iam atul joshi from mechanical branch. i want to know about the syllabus of technical ques of jindal steel
what is cyclon seperator and water column?
What do you understand by eutectic ?
. What is a magnetic valve of refrigeration system?
What is a time and motion theory?
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
