How power factor affect on bill explain with example.
- 13 Answers
- 27803 Views
- I also Faced
- E-Mail Answers
Answer Posted / muhammad farooq khan
cos(phi)is a power factor. cos theta is a angle. so use
proper terms while answering to the questions. don't
misguide us.
please
| Is This Answer Correct ? | 6 Yes | 9 No |
Post New Answer View All Answers
diff.between servo motor and ac motor
What are the differences between single phase and three phase?
How Calculet The UPS AH In Load
differnce between single acting and double acting solenoid valves
Why to keep capacitor bank off while generator running.
What is the relation between frequency and motor rpm?
do you have some of interview Questions in power and genrator section in general whith answers
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
how withstand of hi-pot test outputs of transformer wire 2.5mm
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
aternator every parts and its working
Igfet is a
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
how to find the resistance and gap volatage of the diode??
What does the letter CTNM in negative phase sequence relay means?
