What is pressure,What is temperature,What is flow,What is
level
- 4 Answers
- 9483 Views
- Keltech, Petrofac, I also Faced
- E-Mail Answers
Answer Posted / mahesh
Pressure :Force per unit area.
Temperature:Degree of hotness or coldness.
Flow :Volume of fluid which passes through surface
per unit time
Level :Quantity of liquid/solid held by the container
| Is This Answer Correct ? | 78 Yes | 0 No |
Post New Answer View All Answers
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
Explain about the leakage class of the control valves
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
Exothermic reaction./ endothermic reaction
How to convert milliampares into flow??
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
selection criteria of control valve? and selection criteria of actuator explain in brief?
how to calculate control valve bonnet size?? or how to select its material?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Programmable Logic control.
Explain bernoulli’s theorem.
