Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
Answer Posted / ricky
Hi dude, Cud u explain the exact problem ur faceing on EIGRP
configuration. If there is no configuration problem thn it
wud be a packet tracer bug. So better uninstall it & restart
ur pc & thn install again..!!
As Jitu & Shahin, indicated the probelm, apart from this i
got nthgn is wrong.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
In which access- list type you can't do editing?
What is the difference between the communication and transmission?
How many parts of ping?
What are the different types of VPN?
What is the formula for metric of ospf?
What purpose does aging serve in a link state protocol?
Which way of communication bus topology use?
Which dynamic type draw back is, if single link down, it removes its routing table?
Define the igp (interior gateway protocol)?
Explain how many broadcast domains are in switch?
1900 Value in which type of access list?
Can you define LAC
Default packet size of ipv6?
What is the syntax of ipv4?
When we use router?