Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
- 20 Answers
- 22512 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera sina
can u provide me
#show run out put and show ip interface brief out put befor
doing this plz implemet no keepalive at ehthernet interface
after doing this send me the outputs
becoz configuration look good
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Tell me which multicast ip eigrp protocol use?
which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?
In which protocol supenetting is enable by default?
What are the differnt memory use in cisco router?
Which ipsec rule is used for the olympia branch and what does it define?
What do you understand by poe (power over ethernet)?
What are the steps of conversion for data encapsulation?
Which LAN switching method is used in CISCO Catalyst 5000?
Explain dhcp scope?
What is difference between igp and eigrp?
Define class full protocol?
Which cable we connect in db-9?
What is the virtual path?
What is difference between switch & hub?
Explain the benefits of VLANs.
