Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
Post New Answer View All Answers
What is the purpose of data link layer?
What are the things that can be accessed in a CISCO router’s identifying information?
What is the difference between an igp and an egp?
What requirements should a VPN fulfill?
What is hold down time formula of ospf?
What is ping? What is the usage of ping?
What is icmp protocol?
Mention what is the difference between tcp and udp?
What are the protocols that are used by every layer of ip/tcp model?
Explain the difference between flsm and vlsm?
What are the types of resource sharing?
What is the difference among straight cable, cross cable and rollover cable?
What is formula of hold down time of eigrp protocol?
What do you understand by redundancy?
Define mac address?