Could anyone clarify my wondering.
What is the difference between knee point voltage and
saturation voltage of the CT.
Is their any formula to calculate these values?
- 2 Answers
- 5449 Views
- I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
The knee point
is a ten percent ratio error between the
primary input current and the corresponding secondary
output current.
The saturation point involves determining the secondary
voltage necessary to drive the measured current through the
impedance of the secondary circuit.
For More Details,Pls visit
http://www.control.com/thread/1026243854
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Pl. brief about break-down maintenance of machine tool.
how we provide neutral earth on synchronising panel as per electrical standards?
DC transmission
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
Give atleast 20 alternating current apparatus and devices.
What is transient response?
What are the Full Forms of TVM, MTL, CVT ?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
What is the capacity of the Fastners 12mm?
What are the uses of stepper motor?
What is polar plot?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How one can check the MAIN of a house wiring ?
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
