Interested to Buy Any Domain ? << Click Here >> for more details...
The stage below saturation is called?
Cox chart is used in ....Distillation, evaporation, drying
r none?
- 3 Answers
- 11231 Views
- TCE, I also Faced
- E-Mail Answers
Answer Posted / sharan
compressed or subcooled liquid
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?
A very strange fault i cam across today,that i never experienced not studied before, i need an answer for this. Phase to phase or line to line , L1,L2 & L3, voltages are 490VAC, but if i use line to ground , its again 490 VAC. . . whats the fault and theory behind of it?
At 50 Centigrade (Fuel oil) what is its cast?
What is the law of thermodynamics?
how water evaporated in sea
what is the difference in Gas Welding and Gas Cutting?? Second Question is for Huge Casting which method is used??
Explain the difference between projectile motion and trajectory?
Why are not use ball bearing insted of roller bearing?
Explain the working of 6 stroke engine?
Give an introduction to bourden pressure gauge?
Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.
Where does Parallel flow heat exchanger use?
What is difference between Higher calorific value and lower calorific value?
DIFFRENCE BETWEEN ISO AND TS
explain the mixture requirement of si engine to meet the demands of various operating condition?
