the minimum percentage of steel for 2m rcc slab
- 7 Answers
- 18099 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / gokul
0.15%bD
| Is This Answer Correct ? | 28 Yes | 6 No |
Post New Answer View All Answers
I want to join bhel because
Explain what is the difference between built area and super built up area?
Ratio for 4500 psi concrete
why should we use 20mm graded metal only in vrcc?why we shouldnot use 40mm metal?
how to calculate the density for high density concrete ? or is it same as the density of RC?
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
in one SQM plaster how much Cement and sand consumed in ratio 1:4
How to come 1.54 from dry to wet concrete?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
In reclamation works what are the importance of geotextiles and sand?
how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress
why the profile of shell of natural draught cooling tower is hyperabolic.
What is an ortho mode?
I am a civil engineering student and going to attend interview in this week in an IT company.Will they ask me questions about my area of interest or cs
