What is the diffrece between CAPACITOR BANK & CAPACITOR OF
MOTOR?
- 4 Answers
- 6720 Views
- I also Faced
- E-Mail Answers
Answer Posted / badmalia rajesh
Actully capacitor bank is used for power system power
factor improvement. that contains theree capacitor of large
capacity conneted in either star or in delta connection.
While capacitor used in motor is not of that moch big
capacity the used for starting of single phase induction
motor and for their quit operation. The capacitor used in
motor is generally single phase.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
How to minimize the eddy current losses?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
how to decide no of electrodes for 1600A LT Main incomer panel
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to carried out DAR test in 11 KV Alternator ?
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
what is transformor oil gread
What does the term power factor shows?
