When a timer is placed in RS Logix 5000 with preset value
less than its scan time it is malfunctioning. i.e., if the
preset is set to 30ms still the timer TT bit is counting
till 150ms(its scan time). Any solution for the problem?
- 2 Answers
- 7094 Views
- Balco, I also Faced
- E-Mail Answers
Answer Posted / kean barton
I added a periodic task that runs every millisecond. The
main program has a max scan time of 15 millisecond but I can
still use timing down to the millisecond in that routine.
Good luck with it!
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the cascade control
What is the minimum rating availalbe for weld neck orifice in market?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
please send the drdo exam paper
whats the abbreviation of IOP? is it instrument of power or input open problem?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
send me last 5 years questions asked in rrb chennai, for section engineer
How to Calibrate Flammable gas detector in field
Why plc require in analog input 4-20amp & 0-10 volt?
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
sir, give me placement papers and interview quistion of birla group company of copper.
control panel design guidelines
What are the interlocks we have to check during the start up of LP/HP compressor?
