what will happen if the secondary of current transformer
kept open....
- 11 Answers
- 15656 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudhar
if secondary is kept open,the rated current inthe primary
will be induced in the secondary side.due to open ckt,the
curent wil be zero.so high voltage will pass which will
burn the secondary coil and the devices connected to it
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
How much earthing frequency is capable?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
tell me about roaster switch .& what is the function in transmission & distribution?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What does bode plots shows?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
What OPGW is better than Microwave or PLCC???
What is Harmonics how it is produced and what is the method to control the same
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
33kv Rated output avilable in market (any where in india)
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is the meaning of loop in transformer
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
