what will happen if the secondary of current transformer
kept open....
Answer Posted / hareesh
it is normally a step up transformer,high voltage will
induse in secondery since there is no opposing flux for
primery.it is normally used for measuring purpose no current
will flows through it.flux will saturate.
Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
what is the purpose of using filters in a protective relaying scheme?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
How To increase Knowledge Of boliler regarding To Only Electrical Field..
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
distribution is maximum done by a)radial b)network c) parallel d)b & c
what is the current setting for different relay protection for transformer .
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
how you taken aotitude test
What is the power requirement of tamil nadu for one month?
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
What is the distance between each insulator in 33kv transformer and how can it calculate
can any tell me why slope 40% and 80% is calculated in differential protection?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket