protection used for alternator , feeder , transmission line
Answer Posted / vinodh.t
fallowing protection are used for alternator
1.differential
2.negative phase sequence
3.over voltage
4.over current
5.thermal overload
6.under frequency
7.earth fault
8.over fluxing
9.over frequency,etc
feeder protection
1.over current
2.earth fault
transmission protection
1.over current
2.earth fault
| Is This Answer Correct ? | 29 Yes | 1 No |
Post New Answer View All Answers
what is transistors comprised of?
What do you understand by oldham's coupling ?
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
what is the solution for meger test failed the MV cable?
hello if any one have papers vof hpcl or sail, plz send me
What does the term power factor shows?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
3phase cable calculation formula by motor load
sir i want previous entrance exam papers for written test
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
11 kV line deraction check by an Engineer.
what you have to see after one week or month from the day of installation of transformer ?
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?