How can we calculate the rating of capacitor bank to be
connected for a particular load(ex.100kw)to improve the
power factor from 0.8 to 0.9?
Answer Posted / pasuvaraj
Mr Ravikumar, When your calculating the KVAr, you using the
KW in the Formula, How you consider the KW, The KW after
the KVAR Added or Before Added. This my doubt in your
formula you have explained
Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
what is the difference between torque induced and torque load?compare them with respect to dc motor?
What is the bundle conductor?
Comment on the working principle of operation of a single-phase transformer.
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
how ups works ? various parts of ups and working principle
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
is it possible to start a motor in felid connected to a remote mcc
What is the formula to find out two phase active & reactive power
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
How the capacitance og capacitor volatage transformer is decided?
how i can calculate the size for fire cable
Why does the rotor rotate?