why the crow do not feel the current in overhead line when
it sits on the wire??????
Answer Posted / rajagopal
It is sitting only one conductor its never touch any other
conductore or ground so it is single pottencial. if you
want any circuit closing thuse want phase neutral or two
phase and three phase
Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Do you know what is dry-out test in x'mer
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
How we calculate the size of ht cable for any transformer
Electrical 'C' license full abbreviation , and full form
what is your aim
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
what is die electric strnth of transformer ?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
what is the correct format to create a resume for interview??
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
how to avoid Saturation in C.T?