I WANT TO KNOW LONGFORM OF CT/PT USEDIN POWER PROJECTS OR
HT SWITCH YARD.
Answer Posted / jyotirmaya
CT- Current Transformer.
Its primary side is always connected in sereis with the
supply system . It normally steps down the current from high
value to low value.
PT- Potential Transformer.
Its primary side is always connected in parallel to the
supply system.It normally steps down the voltage from high
value to low value.
CT & PT are called instrument transformers and used for
metering and protection purpose.
| Is This Answer Correct ? | 19 Yes | 3 No |
Post New Answer View All Answers
send me any model test paper of clerical post of state bank of india.......
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
difference between high and low impedance BUS BAR relay??
How halogen & merquery lamp works.
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
What is Fire Panel ? How it works ?
What is called limb of a transformer?
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
why tertiary winding is used in transformer with diagram?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
Define coil span?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters