What are the minimum acceptable insulation resistances of
insulation of underground cable suitable for 0.440kV,11kV,
33kV and 66kV?
- 2 Answers
- 5429 Views
- I also Faced
- E-Mail Answers
Answer Posted / hardik vyas
A Thumb Rule for acceptable IR value of vable is (Rated
KV+1)M Ohm. i.e if you have 11 KV cable then accepted
value vill be 11+1=12 M Ohm
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
what is the ATS .And how it works.
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Explain about retrofitting of machine tool.
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
I am interested to know what does 15 KVA DG set actually means? If I dont know the DG rating, is it possible to identify KW by simply knowing the diesel consumption?
how to calculate energy of 3-phase motor?
What do you mean by an instrument transformer?
Draw the DOL starter and star delta starter drawing?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
how to calculate the distance relay faulty zone?pls explain?
which protection function should measure RMS value of current&DFT value of current?
why HT armoured cable does not glanding
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
