Hi Guys
I am facing one problem while configuring PAP over Point to
Point links. Configuration scenario is like this.
ROUTER 1: (Hostname – R1)
R1(config)#username R2 password CCNA2
R1(config)#interface serial 1/1
R1(config-if)ip address 10.0.0.1 255.0.0.0
R1(config-if)#lock rate 64000
R1(config-if)#encapsulation ppp
R1(config-if)#ppp authentication pap
R1(config-if)#ppp pap sent –username R1 password CCNA1
R1(config-if)#no shutdown
ROUTER 2: (Hostname – R2)
R2(config)#usename R1 password CCNA1
R2(config)#interface serial 1/1
R2(config-if)#ip address 10.0.0.2 255.0.0.0
R2(config-if)#encapsulation ppp
R2(config-if)# ppp authentication pap
R2(config-if)# ppp pap sent –username R2 password CCNA2
R2(config-if)#no shutdown
Now problem is that, after configure the command “ppp
authentication pap” the “Line protocol” status goes down on
each router. But when I disable this command using “no ppp
authentication pap”, the “Line Protocol” status goes up.
What could be the problem, can anyone explain it plzzz….!!!
Thanks in Advance…!!
Shahin..
- 6 Answers
- 7526 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahin
ok... Jitu.. I m agree with u.. but we have to configure
clock rate only on DCE router... M i ryt?????? There is no
need to configure clock rate on DTE router, as it
synchronise according to DCE router.
i got this concept somewhere in books & i also tried this
in PACKET TRACER. I also saw the line status & protocol
status. All are in up state, when i configured clock rate
on DCE & i left DTE.
U cn try this on packet tracer.
Let me know.. Is it correct or wrong?????
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are 10base2, 10base5 and 10baset ethernet lans?
What port does rip use?
Why ip address called logical address?
What is the difference between csma/cd and csma/ca?
What is the draw back of eigrp protocol?
Which company mange ip's?
Name the protocol which can do load balancing on unequal cost also?
What is the second best path name of eigrp?
Which ipsec rule is used for the olympia branch and what does it define?
Differentiate Logical Topology from Physical Topology
Explain the types of ospf configuration?
How does cut-through LAN switching work?
Which multicast ip eigrp protocol use?
How do you configure a cisco router for routing ipx?
In stead of 0.0.0.0 wild card mask what you can write after ip?
