Answer Posted / mukhesh
ther is no form factor in dc f f is ratio of rms value
and avg value
rms only in ac means max value in dc avg value taken
| Is This Answer Correct ? | 6 Yes | 10 No |
Post New Answer View All Answers
What is Tachometer used to measure?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
What is different between resistance grounding system and resistance earthing system?
what is the requirement regarding earthing of Single conductor with AWA
what is the efficiency of thyristor
how does this job compare with others you have aplied for?
What is the capacity of the Fastners 12mm?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
