Answer Posted / mukhesh
it is power is devoloped in that plant useing electrical
equpiments and then tranansmitt power to disturbutor on
economical basis
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
1.4 What is meant by CT knee point voltage and how would you determine it
What is a single phase autotransformer?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
In parallel operation time both NGR’s close or not close if both close what will happen
What is dielectric loss?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
what is the solution for meger test failed the MV cable?
What is power in wattage of 8.5 TR AC
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
Can RCD's used to protect the VVVF drive if not why.
