Is there any difference between circuit breakers and
isolators
Answer Posted / m.surendar
isolator is a just likes as a on and off switch .but we can
operate local and remote operation in C.B . C.B also trip
the electrical system while occured the fault.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
why do we have spikes enough to burn electronic boards, when generators are not grounded
SUTIABLE FOR ohm's law super conductor
What is meant by stator? What is meant by rotor?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
What happens if we connect a single phase energy meter in reverse polarity.
How I calculate the ELCB for circuit breakers?
1.what is mean by 8/20 micro sec waveshape
state types of reflectors in illumination engg. ???????
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
Pleae send me last 5 years of Question book about RRB chennai.
why the carbon brushes are broken in srim while the motor runningtime