what is diff between sensors and transducers.explain with
ex?
Answer Posted / ashokkumar
Sensor is a device which measures a physical quantity like
vibration ,temperature,humidity,pressure,speed etc and
converts in electrical form depending on the sensor
properties whether active or passive type.
Transducer is a device which converts one form of energy
into another form.That may be from voltage to current or
temperature to voltage.
So all sensor can be transducer but all transducer can't be
sensor.
Is This Answer Correct ? | 20 Yes | 6 No |
Post New Answer View All Answers
What is offset in a control system.
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
what is thermo coupler and how it works
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is standard procedure of manual mapping in Radar type level transmitter?
How will you calibrate PID controller? explain with example.
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
Galvanizing.
What is the GK Value in Flowmeter?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,