Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bharathi
To avoid stray current in the loop
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what are the use of belew gear in general ??
What is the Working principle of Dozing valve?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
what is performance test.need defination
What is cut off relay? And why use in PLC and DCS?
what is the difference between magnetic flow meter and mass flowmeter
how to calibrate Necleuonic level transmitter.?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
Give Detail information about plc,dcs,and scada system?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
kindly sent some demo question and answer
whatis range of marcury filled tempereture gague
What is furnace draft control?
