Answer Posted / zulfiquar wani
DC supply we are using for the control circuit becoz it is
a continous supply for control circuitary for signaling and
even for tripping even if the AC fails.... becoz DC is
always available and also we are using DC backup for
emergency tripping of lighting system
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
what is errection pcbs?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
What type of fittings and electrical accessories can be install in radiation area ?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
how to handle 2500 kva transformar
What are the different types of transformers?
How many turns are there in primary winding? (In Transformer)
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the Nyquist criterion regarding control systems?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
