Why the rating of the HT breakers are in 1250 Amp, while
the load on the breaker is around 50 Amp. ?
- 9 Answers
- 22241 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / ajay
I think it is according to its circuit breaking capacity at
fault, that how much current it can bear durring breaking
of curcuit
| Is This Answer Correct ? | 3 Yes | 13 No |
Post New Answer View All Answers
What do you mean by passive circuit elements and why these are called passive?
What are the uses of lead compensator?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
how to check three phase motor torque value?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
I Want randstand placement papers
What is purpose of reactor?.What is different between line and bus reactor?
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
What is the need for a controller?
Which test will be more severe for VCB?
Enlist four components of electrive drives.
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
difference between a diode and thyristor?
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
