Interested to Buy Any Domain ? << Click Here >> for more details...
Why electricity is generated and transmitted at the values
of multiples of 11?
- 3 Answers
- 7368 Views
- I also Faced
- E-Mail Answers
Answer Posted / ishaan
The electricity is generated and transmitted at the values
of multiples of 11 because the value of form factor is 1.1
for sinusoidal waves, we generally incoorporate sine wave,
cose wave for electrical signals and at this value of form
factor, the efficiency of any electrical equipment is
maximum. More precisely we would say these are the
multiples of 1.1 like 6.6 etc.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
Write down the name of 2 lady Bir Pratin of Bangladesh
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
what is through fault?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What is the basic of DTH.
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
why current flow to the opposite direction of flow of electrons???????????
what is electrical machines
