what happens if i connect acapacitor to a generator load
- 5 Answers
- 13021 Views
- I also Faced
- E-Mail Answers
Answer Posted / phanendra babu
if we connect the capacitor across the alternator for
compensating the inductive load it will be more use full,
improves the p.f hence reduces the load on the Altrnatr. if
it is under no/light load condition,alternator output
voltage will increase more than the rated,hence connected
load will be effected and hissing noise will observe from
the alternator,hence it will effect the efficiency and life
of the alternator
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
description about dry type transformers
what are the preventive maintanance actions taken for air circuit breaker? please answer me
What is transmittance?
Define gain margin?
What cmos is and its benefits?
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is the Resposiblity of Electrical Utility Engineer
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
What is meant by impedance? difference between high & low impedance ?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What is the necessary and sufficient condition for stability.
