Interested to Buy Any Domain ? << Click Here >> for more details...
Did you handle any interior designing jobs?
- 5 Answers
- 14839 Views
- Shell, I also Faced
- E-Mail Answers
Answer Posted / meenal
no
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What Are The Different Type Of Slump Test Indications?
Providing and casting in situ cement concrete M-25 of trap/granite/quartzite/gneiss metal for rcc, Providing formwork,Curing the concrete and Complete. what is rate per Cum. and what is rate for M-30 Grade Concrete.
how to determine H- zone in a column? where it will occur?
quantity of sand and cement for 10m2 plastering 10mm thick for the ratio of 1:4,1:3and its leabour data
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
Concrete cover for slab, column, beam and footing?
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
why we create short columns under grade slab?
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
What should be the standard roof height like to be?
