Answer Posted / sunil datta
The Basic difference between UPS and Invertor is of
switichover time .This S. O. time is considerably very
small in cse of Ups.ans does not intruppt electronics
load.
| Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
how we explain parallel paths armature winding?
Starting current of a 10 HP induction Motor is ______ time’s full load current.
how to apply b license to c license in tneb
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
why we use copper earthing for neutral while for body GI.
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
why occ characteristics of generator is also called as magnatization characteristics ?
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
What are the factors influence the choice of an electrc drive?
what are the pecularity of shaver sockets ?
what is class of SPD and dittels of all class ?
What does ampere turns shows?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
