cetane no. and sulphur required in diesel fuel for euro-IV
- 2 Answers
- 5767 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / aroh shrivastava
cetane no. = 45-48
sulfer content = 0.05%
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
What is a good source of surfactant information on the internet?
design calculations for reactor
What is the use of gear pumps in motor?
What steps can be taken to avoid stress corrosion cracking (SCC) in steel vessels used for storing anhydrous ammonia?
How can separation of chiral chemicals affect the chemical and/or pharmaceutical industries?
X is strong but has a very low density (1% of traditional earth materials.) and hence light weight. It is a recyclable material. The compression behaviour of X is strain rate dependent. Higher strain rates result in higher initial modulus and higher compression strength. It can also withstand unlimited number of cycling loading provided the repetitive loads are kept below 80% of the compressive strength. The internal structure of the material includes air-traps which make it poor heat conductor. X is non- biodegradable and chemically inert in both soil and water. Most acids and their water solutions do not attack it; however strong oxidizing acids do. Solvents which attack X include esters, ketones, ethers, aromatic and aliphatic hydrocarbons and their emulsions, among others. It does not support bacterial/fungal growth as well .It also has significant acoustic properties and effectively reduces the transmission of airborne sound. X is combustible and should not be exposed to open flame or other ignition sources. Combustion products are carbon monoxide, carbon dioxide, water and soot. Long-term exposure to sunlight causes yellowing and a slight embrittlement of the surface due to ultraviolet light. X is able to withstand the rigours of temperature cycling, assuring long-term performance.
Explain how can viscosity affect the design of a mixer?
Explain what type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
How much water is lost through a commercial cooling tower system with a throughput of about 600 gpm?
What do we use carburizing/nitriding chemicals for?
Hi, I am Gurunathan. I am in need of ONGC, IOCL, DRDO technical test ( chemical engineering)and general aptitude questions. If anyone has kindly post it to me soon.
sir i am appearing in railway exam of section engineer and my branch is chemical engineering i want previous question paper of section engineer of chemical branch please tell me as soon as possible my email id is surendrasaroj18@gmail.com THANKYOU
oil field interview question
What type of flow measurement devices is best for slurries?
What is a good source of information for the design of pressure vessels?
