Which is more Elastic Steel or rubber? Plz give the reason
also........ mchandan86@gmail.com
- 18 Answers
- 39228 Views
- I also Faced
- E-Mail Answers
Answer Posted / krishna
I need more clarification from all,
I think, you are thinking about elastic strength. elasticity
is different from elastic strength.
Of course steel has high elastic strength(youngs modulus)
but it has low elasticity. It couldn't get original shape
still the deformation is lower than rubber and elastomer
materials.
for an example take a piece of rubber and steel
under application of load rubber and steel both gets
deformation but rubber only can get its original shape after
removal of load(though the load is much lower than steel)
steel needs more load to deform because of high elastic
strength only.
| Is This Answer Correct ? | 19 Yes | 11 No |
Post New Answer View All Answers
What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.
What are the different types of fits? Explain
The graphite in grey irons exists in the form of flakes which act as stress-raisers under tensile loading and consequently grey irons have relatively low tensile strength and ductility. Still grey iron is extensively used in engineering. Why ?
Name the operation which can be performed by lathe machine?
On which analysis is based the dulong’s formula for the heating value of fuel ?
Why consumption of lubricating oil is more in two-stroke cycle petrol engine than four-stroke cycle petrol engine ?
Small gear found in the steam turbine.
What is the indication of leaking starting valve of an engine?
Why will an ice cube placed in a cup of hot rotating water spin automatically faster than the water itself?
What is the most important thing you have achieved as an engineer?
please send jindal steel and power model question papers
SIR plz send me old exam papers for RRB chennai
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
I've been running into situations where a relief valve is being used to protect a regulator. Is this common? And, is this a proper use of a relief valve?
how to calculate bearing width
