Answer Posted / somasekharan
hmi is located in hazardous area,it shall be flameprrof
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
give some question relative instrument fitter?
What is profibus?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
Differentiate between ultrasonic flowmeter and radar type flow meter
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
why is an oxygen sensor used in a boiler stack
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is instrumentation instrumentation engineering?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
How hart protocol can be connected with control valves?
What is rang ability?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
any body please send me the old question papers of ongc test.