Answer Posted / awais
PLC The Programable logical controller is a solid state
equipment design to perform logic design for industrial and
home automation.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In turbine what does term CDP, NI, NH, HSSOC means.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
draw shematic diagram of c/v positioner(smart type)?
What is standard procedure of manual mapping in Radar type level transmitter?
if in a level tx height is given, how u calculate the ranges of the tx?
what is the vital subject for scoring bhel exam&what is the question pattern
State some of balance principle’ advantages?
Decibel.
how to check earthing,what is minum ohms for proper earthing
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
what is the calibration procedure for transweigh make weigh feeder?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
