Why any transmitter signal is 4-20 mA only
Why is started from lower range 4 mA and upper range is
20mA.
- 5 Answers
- 10884 Views
- Edac, I also Faced
- E-Mail Answers
Answer Posted / anshul jaiswal
if we use 0-20 mA scale for 0-100%,then 0% will be read in two cases;1)when instrument has any kind of damage problem(not responding case)& 2)for the ground level reading.so we use 4-20mA which shows 4mA for 0%(ground level) & 20mA for 100%(full value) and 0mA shows that instrument has any damage problem.And guyz,in the range of 4-20mA the calibration shows linear characterstic too.
| Is This Answer Correct ? | 30 Yes | 3 No |
Post New Answer View All Answers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Name different parts of a pressure gauge.
what is the difference between magnetic flow meter and mass flowmeter
why we r opening HOT BYPASS valve during startup of a compressor?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
How many interlocks at turbine? Plz explain briefly
Calibration of controller (pneumatic)
What is 3 element control system
If P will increase then what will happen with PID?
What is the use of gauge?
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
Explain about safety integrated level protection? . How it was differ from other protections ?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
what is performance test.need defination
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
