how does electrical train works and what type of motors are
used to drive the train?
which level of supply voltage is used?
- 22 Answers
- 59463 Views
- Alstom, Infotech, I also Faced
- E-Mail Answers
Answer Posted / bhanu
Electric train runs by using either DC Series Motor or 3-
phase Induction motor
the train receives 25kv voltage, transformer in it steps
down the voltage to 600v ac and then converted to dc for dc
series motor and 750v ac for induction motors.
| Is This Answer Correct ? | 31 Yes | 20 No |
Post New Answer View All Answers
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
what is the difference between an alternator and a synchronous motor
what does mean of RCT and STR in diffrential CT?
What consists of 2 or more thermocouples to be connented series?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
How to decide whether A / B / C / D curve type MCB should be used?
what is the use of permanent magnet generator in exciter
What is a DC series motor?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
Define thermal resistance in the context of power amplifier.
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What are IR values and what it should be for coil and for insulator
